Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Problem
The clothes have lint
on them.
Water is not draining.
Items still wrinkled
after Wrinkle Prevent
(Wrinkle Away, Wrinkle
Release).
Water drips from the
nozzle when the Steam
cycles starts.
Sprayed water is not
visible during Steam
cycles.
Extended time.
If the problem continues, contact a service center. The number of the service center is on the label attached
to the product.
92
English
Untitled-1 92
• Always make sure the lint filter is clean before putting items into the dryer.
When drying items that generate a large amount of lint, you may need to
clean the lint filter in the middle of a cycle.
• Some fabrics (such as white towels) causes more lint and should be dried
separately from fabrics that lint attaches easily (such as black linen pants).
• Check the inside of the pockets to make sure they are empty before drying.
• Check the draining hose for twists and kinks. Straighten out the hose if it is
twisted or kinked and securely connect it to the drain on the floor.
• Check to see if the draining hose is frozen. If the hose is frozen, submerge
it in warm water to allow the water inside the hose to melt and drain out.
Reconnect the hose and check for proper draining.
• Small loads of 1 to 4 items work best.
• Load fewer items. Load similar-type items.
• Take out the items immediately after drying is complete.
• This is steam condensation. The dripping water will stop after a short time.
• Sprayed water is difficult to see when the door is closed.
• Sensor Dry automatically senses the moisture in the load and shuts the
dryer off when the selected dryness level is reached.
The drying time can change according to the type and amount of laundry.
See the cycle chart for reference.
Action
2023-12-18( )
5:49:41
Publicité
