Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Problem
The door does not
open.
Excessive suds.
Cannot add additional
detergent.
Stops.
88
English
Untitled-1 88
• Tap
to stop the washer.
• It may take a few moments for the door lock mechanism to disengage.
• The door will not open until 3 minutes after the washer has stopped or the
power has been turned off.
• Make sure all the water in the drum is drained.
• The door may not open if water remains in the drum. Drain the drum and
open the door manually.
• Make sure the door lock light is off. The door lock light turns off after the
washer has drained.
• Make sure you use the recommended types of detergent as appropriate.
• Use high efficiency (HE) detergent to prevent oversudsing.
• Reduce the detergent amount for soft water, small loads, or lightly soiled
loads.
• Non-HE detergent is not recommended.
• Make sure the remaining amount of detergent and fabric softener is not
over the limit.
• Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit breaker.
• Close the door, and touch and hold
the washer will not tumble or spin unless the door is closed.
• Before the washer starts to fill, it will make a series of clicking noises to
check the door lock and will do quick drain.
• There may be a pause or soak period in the cycle. Wait briefly, and the
washer may start.
• Make sure the mesh filter of the water supply hose at the water taps is not
clogged. Periodically clean the mesh filter.
• If the washer is not supplied with sufficient power, the washer will
temporarily not drain or spin. As soon as the washer regains sufficient
power, it will operate normally.
Action
to start the washer. For your safety,
2023-12-18( )
5:49:41
Publicité
