GreenWorks STE457 Manuel D'opérateur page 7

WARNING
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
8.2 ATTACH THE GUARD
WARNING
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a
screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw holes
on the trimmer head.
4. Tighten the screws.
8.3 ASSEMBLE THE SHAFT
1. Loosen the knob (13) on the coupler (8).
2. Push in the release button (14) on the lower shaft (9).
3. Align the release button with the positioning hole (15)
and move the two shafts.
4. Turn the lower shaft until the button locks into the
positioning hole.
5. Tighten the knob.
English
15
15
9
14
8.4 ATTACH THE AUXILIARY
HANDLE
1. Remove the knob (18) from the handle.
2. Attach the auxiliary handle and lower clamp (17) on the
shaft.
3. Set the auxiliary handle in the comfortable position.
4. Put the bolt (16) through the holes.
5. Tighten the auxiliary handle with the knob.
8.5 INSTALL THE BATTERY PACK
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read and understand the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
7
8
13
16
17
18
WARNING
EN