Pioneer S-DV940ST Mode D'emploi page 85

Additional information
Tuner
Problem
Considerable noise in
radio broadcasts.
Auto tuning does not
pick up some stations.
Sound is mono only.
Error Messages
Message
Child Lock
Rec Mode On
Phones In
96K Stereo
No Surr. SP
Muting
Exit
Remedy
• Connect the antenna (refer to the Setup Guide).
• Fully extend the FM wire antenna, position for best reception, and secure
to a wall.
• Connect an outdoor FM antenna (see Connecting external antennas on
page 73).
• Adjust the direction and position for best reception.
• Connect an additional internal or external AM antenna (refer to the Setup
Guide and Connecting external antennas on page 73).
• Turn off any other equipment that may be causing the noise or move it
away from the main unit.
• The tuning interval is incorrect for your country or region. Try switching
the tuning interval (frequency step) (see Changing the frequency step on
page 77).
• The radio signal is weak. Auto tuning will only detect radio stations with a
good signal. For more sensitive tuning, connect an outdoor antenna.
• Check that the tuner is not set to FM mono (see Improving poor FM
reception on page 29).
Desciption
• This message appears when the front panel buttons are pressed when
the child lock feature is active. See Child Lock on page 77 for more on
switching on/off the child lock.
• Blinks rapidly for 2 seconds when an operation is prohibited because the
Recording Mode is on (see Recording mode on page 75).
• Blinks rapidly for 2 seconds when an operation is prohibited because
headphones are connected.
• Blinks rapidly for 2 seconds when an operation is prohibited because the
source is digital 88.2 or 96kHz PCM.
• Blinks rapidly for 2 seconds when an operation is prohibited because
there is no surround speaker output.
• Blinks rapidly for 2 seconds when an operation is prohibited because the
sound is muted (see Muting the sound on page 37).
• Appears briefly when a menu is automatically exited after a set period of
inactivity.
12
85
En