Publicité
Les langues disponibles
Les langues disponibles
Initial Settings menu
Component Out
You only need to make this setting if you
connected this system to your TV using the
component video outputs.
• Default setting: Interlace
Initial Settings
Digital Audio Mode
TV Screen
Video Output
Component Out
Language
S-Video Out
Display
Options
If you have a progressive-scan compatible TV,
set this to Progressive for flicker-free video
output. If your TV is not compatible with
progressive-scan video, set to Interlace.
Check the operating instructions that came
with your TV if you're unsure about its
compatibility.
When setting to Progressive, you have to
press ENTER once more to confirm (or
RETURN to cancel). See also below for
important information on progressive scan
video.
About progressive scan video
Compared to interlace video, progressive
scan video effectively doubles the scanning
rate of the picture, resulting in a very stable,
flicker-free image. Progressive scan video is
available only from the component video
output.
• When Component Out (above) is set to
Progressive, there is no video output
from the VIDEO and S-VIDEO jacks. If you
want to display video on more than one
monitor simultaneously, make sure that it
is set to Interlace.
• If you connect a TV that is not compatible
Progressive
Interlace
Compatibility of this system with
progressive-scan TVs.
This system is compatible with progressive
video Macro Vision System Copy Guard.
CONSUMERS SHOULD NOTE THAT NOT ALL HIGH
DEFINITION TELEVISION SETS ARE FULLY
COMPATIBLE WITH THIS PRODUCT AND MAY
CAUSE ARTIFACTS TO BE DISPLAYED IN THE
PICTURE. IN CASE OF 525 PROGRESSIVE SCAN
PICTURE PROBLEMS, IT IS RECOMMENDED THAT
THE USER SWITCH THE CONNECTION TO THE
"STANDARD DEFINITION" OUTPUT. IF THERE ARE
QUESTIONS REGARDING OUR TV SET
COMPATIBILITY WITH THIS MODEL 525p DVD
PLAYER, PLEASE CONTACT OUR CUSTOMER
SERVICE CENTER.
This system is compatible with the following
Pioneer displays and monitors: PDP-503HDG,
PDP-433HDG progressive scan-compatible
TVs.
with a progressive scan signal and switch
the system to progressive, you will not be
able to see any picture at all. In this case,
press STANDBY/ON to put the system
in standby, then press and hold the front
panel (stop) button for about 8 seconds
until the display shows Mem.Clr.?. Press
the front panel VOL – or + button so that
the display shows Interlace?. Press the
front panel button to set to interlace
and switch the system back on.
10
65
En
Publicité
