Pioneer S-DV940ST Mode D'emploi page 63

Initial Settings menu
Chapter 10
Initial Settings menu
Using the Initial Settings
menu
The Initial Settings menu gives you complete
control in setting up your DVD system,
including video output settings and parental
lock settings, among others.
If an option is grayed out it means that it
cannot be changed at the current time. This is
usually because a disc is playing. Stop the
disc, then change the setting.
1 Press HOME MENU and select 'Initial
Settings' from the on-screen display.
HOME MENU
DVD
Play Mode
Initial Settings
2 Select the setup category from the list
on the left, then select an item from the
menu list to the right.
3 Make the setting you want.
• The language options shown in the on-
screen display illustrations on the
following pages may not correspond to
those available in your country or region.
Video Adjust
Disc Navigator
Digital Audio Mode Settings
Make these settings if you connect an
external digital component to the optical
digital output. Note that DVD-Audio and
SACD audio is not output through this jack.
Dolby Digital Out
• Default setting: Dolby Digital
Initial Settings
Digital Audio Mode Dolby Digital Out
Video Output DTS Out
Language Linear PCM Out
Display
Options
If the connected component is Dolby Digital
compatible, set to Dolby Digital, otherwise
set to Dolby Digital > PCM. Check the
manual that came with the other component
if you're unsure whether it is Dolby Digital
compatible.
DTS Out
• Default setting: DTS
Initial Settings
Digital Audio Mode Dolby Digital Out
Video Output DTS Out
Language Linear PCM Out
Display
Options
If the connected component has a built-in
DTS decoder, set this to DTS, otherwise set to
DTS > PCM. Check the manual that came
with the other component if you're unsure
whether it is DTS compatible.
10
Dolby Digital
Dolby Digital > PCM
DTS
DTS > PCM
63
En