Pioneer S-DV940ST Mode D'emploi page 55

Using the timer
Chapter 7
Using the timer
Setting the wake-up timer
Use the wake-up timer to set the system to
switch on at any time and start playing
whatever source you want.
• The clock must be set to the correct time
for the wake-up timer to work properly
(see Setting the clock on page 20).
STANDBY/ON STANDBY/ON
CD CD FM/AM FM/AM
DVD DVD TUNER TUNER
DISPLAY
DVD MENU
TUNE+ TUNE+
ST– ST–
ENTER ENTER
TUNE– TUNE–
MUTE
MASTER
VOLUME
TV CONTROL
CH
BASS MODE DIALOGUE
AUTO SURROUND
PROGRAM REPEAT
AUDIO SUBTITLE
ZOOM TOP MENU
1
SYSTEM
SETUP TEST TONE
4
QUIET/
DIMMER
MIDNIGHT
7
FOLDER–
CLR
MAIN SUB
L1/L2 L1/L2
TV TV LINE LINE
OPEN CLOSE
RETURN
ST+ ST+
SOUND
VOL
INPUT
VIRTUAL SB
ADVANCED
RANDOM
ANGLE
HOME
MENU
2 3
CH LEVEL
5 6
TIMER/ TIMER/
CLOCK CLOCK
8 9
FOLDER+
0
ENTER
ROOM SETUP
1 Select the source you want played.
For example, press TUNER to select the radio
as your source.
2 Prepare the source.
For example, tune in the radio station you
want to wake up to.
3 Set the volume.
4 Press TIMER/CLOCK twice to reach the
timer menu.
Use the / (cursor left/right)
5
buttons to select 'Wake-Up?' then press
ENTER.
Use the / (cursor left/right)
6
buttons to select 'TimerEdit?' then press
ENTER.
7 Set the switch-on time.
Use the / (cursor up/down) buttons to set
the hour, then press ENTER. Set the minute in
the same way, pressing ENTER when you're
done.
8 Set the switch-off time.
Use the / (cursor up/down) buttons to set
the hour, then press ENTER. Set the minute in
the same way, pressing ENTER when you're
done.
After pressing ENTER this last time, the wake-
up indicator lights, and the switch-on, switch-
off times, the function (DVD/CD, etc.) and
volume are confirmed in the display.
9 Switch the system into standby mode.
The wake-up timer will not work if the system
is left on!
07
55
En