Publicité
Les langues disponibles
Les langues disponibles
OPERATING PROCEDURES
CAUTION:
Keep the tool pointed away from yourself and others at all times.
Do not load fasteners with air connected, safety or trigger depressed.
!
Always wear approved safety glasses and hearing protection when preparing or
operating this tool.
Never use a tool that leaks air or needs repair.
LOADING THE FASTENERS
1.
Disconnect the tool to the air supply before loading fasteners to prevent
fasteners from firing during connection. The fastener driving mechanism may
cycle when the tool is connected to the air supply.
2.
Depress the safe cover to release the movable magazine unit and pull the
magazine out fully as shown in Fig.4.
3.
Place a full stick of the desired type and size of fasteners on the fixed magazine
unit. Up to 100 fasteners can be loaded in the magazine.
4.
Push the movable magazine unit forward until the fixed latch clicks and locks it.
Fig.4
5.
The tool is ready to operate.
NAIL FIRING DIRECTIONS
1.
The depth to which a fastener is driven is determined by both the supplied air
pressure and the drive depth setting wheel, located below the trigger. Test fire a
fastener into a sample of the material you will be working on and check depth. If
a change is desired, adjust the drive depth thumbwheel or the regulator to
supply air at a higher or lower pressure. Test fire another fastener and check
depth again. Adjust as necessary.
CAUTION:
Keep tool pointed in a safe direction at all times.
Never attempt to drive fasteners into materials too hard to penetrate, or at too
steep an angle, or too near the edge of the workpiece. The fastener can ricochet
causing personal injury.
!
Disconnect tool from air supply before doing any disassembly, maintenance,
clearing a jammmed fastener, leaving the work area, moving the tool to another
location, or handing the tool to another person.
Clean and inspect the tool daily. Carefully check for proper operation of trigger
and safety mechanism. Do not use the tool unless both the trigger and the safety
mechanism are functional, or if the tool is leaking air or needs any other repair.
2.
Connect the tool to the air supply. Make sure the air pressure is within the 70-110
PSI limits mentioned in SPECIFICATIONS.
3.
Hold the body and press tool at a 90º angle against the work surface, allowing it
to push the safety assembly in, until the moveable plate contacts the work
surface.
4.
Gently squeeze the trigger to drive the fastener.
5.
Lift the tool off the work surface.
21
Publicité
