Publicité
Les langues disponibles
Les langues disponibles
Electrical Safety
The electric motor has been designed for one voltage only.
Always check that the power supply corresponds to the voltage
on the rating plate.
Your D
WALT tool is double insulated in accordance
e
with EN62841; therefore no earth wire is required.
WARNING: 115 V units have to be operated via a fail-safe
isolating transformer with an earth screen between the
primary and secondary winding.
If the supply cord is damaged, it must be replaced only by
D
WALT or an authorised service organisation.
e
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
•
Safely dispose of the old plug.
•
Connect the brown lead to the live terminal in the plug.
•
Connect the blue lead to the neutral terminal.
WARNING: No connection is to be made to the
earth terminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 13 A.
Using an Extension Cable
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable for
the power input of your charger (see Technical Data). The
minimum conductor size is 1.5 mm
is 30 m.
When using a cable reel, always unwind the cable completely.
Package Contents
The package contains:
1 Rotary drill
1 Side handle
1 Depth gauge
1 Kitbox (K-models only)
1 Instruction manual
•
Check for damage to the tool, parts or accessories which may
have occurred during transport.
•
Take the time to thoroughly read and understand this manual
prior to operation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
; the maximum length
2
Date Code Position (Fig. A)
The date code
, which also includes the year of manufacture,
11
is printed into the housing.
Example:
Year of Manufacture
Description (Fig. A, E)
WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
Variable speed switch
1
Lock-on button
2
Forward/reverse slider
3
Two gear selector
4
Side handle
5
Depth adjustment rod
6
Keyless chuck
7
Sleeve
8
Main handle
9
Screw
10
Intended Use
Your D21441 rotary drill has been designed for professional
drilling and screwdriving applications.
DO nOt use under wet conditions or in the presence of
flammable liquids or gases.
This rotary drill is a professional power tool.
DO nOt let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
•
Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
without supervision.
•
This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with this product.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
Inserting and Removing a Bit (Fig. A)
1. Open the chuck by turning the sleeve
and insert the bit shank.
2. Place the bit in the chuck as far as it will go and lift slightly
before tightening.
3. Tighten firmly by turning the sleeve clockwise.
4. To remove the bit, proceed in reverse order.
2024 XX XX
8
counterclockwise
EngLIsh
17
Publicité
