Publicité
Les langues disponibles
Les langues disponibles
LED Indicator Lights on the Rear of Subwoofer
LED
Blue
Red
Red and blue
NOTE
• If the main unit is powered off, the subwoofer will go into stand-by mode and the STANDBY LED on the rear of the sub-woofer will turn red
after blinking in blue several times.
• If you use a device that uses the same frequency as the Soundbar near the Soundbar, interference may cause some sound interruption.
• The maximum transmission distance of the main unit's wireless signal is about 32.8 ft (10 m), but may vary depending on your operating
environment. If a steel-concrete or metallic wall is between the main unit and the subwoofer, the system may not operate at all because the
wireless signal cannot penetrate metal.
CAUTION
• Wireless receiving antennas are built into the subwoofer. Keep the unit away from water and moisture.
• For optimal listening performance, make sure that the area around the subwoofer is clear of any obstructions.
Connecting an SWA-9500S (Sold Separately) to your Soundbar
Expand to true wireless surround sound by connecting the Samsung Wireless Rear Speaker Kit (SWA-9500S, sold separately) to your Soundbar.
For detailed information on connections, see the Samsung Wireless Rear Speaker Kit manual.
Status
Description
Successfully connected
On
(normal operation)
Standby (with the
On
Soundbar main unit turned
off)
Blinking
Malfunction
-
Check if the power cable attached to the main Soundbar
unit is connected properly.
See the contact information for the Samsung Service
Center in this manual.
ENG - 11
Resolution
Publicité
