Publicité
Les langues disponibles
Les langues disponibles
7
By pressing the button, you can set the audio function such as SpaceFit Sound, AVA, Voice enhance mode, Night
mode, Sync, Virtual. The desired item can be adjusted using the Up/Down buttons.
Sound Control
• Voice enhance mode enhances spoken dialog in movies and TV to make it easier to hear.
• Night mode is optimized for night time viewing with the settings adjusted to bring the volume down but keep
• Press and hold the
• If the video on the TV and audio from the Soundbar are not synchronized, select Sync in Sound Control, and
• Sync is only supported for some functions.
• The Virtual Speaker function can be turned ON/OFF by using the Up/Down buttons.
8
You can also play or pause music by pressing the button.
Play / Pause
9
Press Up/Down/Left/Right on the button to select or set functions.
• Music Skip
Up/Down/Left/
Right
• ID SET
10
Press to display information about the active function or the codec available.
In BT mode, it displays the connected device (when pairing is complete) or "BT ready" (when pairing is required).
Info
11
WOOFER LEVEL
Push the button up or down to adjust the level of the woofer (bass).
12
VOLUME
Push the button up or down to adjust the volume.
• Mute
13
By pressing the button, you can adjust the volume of the treble or bass sound. The defired item can be adjusted
using the Up/Down buttons. This function is enabled in Sound mode excluding in Standard mode.
• To control the volume of the treble or bass sound, select TREBLE or BASS in Sound Settings, and then adjust
TONE CONTROL
• Once the bass level is changed, the woofer level will be also adjusted accordingly.
the dialog clear.
(Sound Control) button for about 5 seconds to adjust the sound for each frequency band.
150Hz, 300Hz, 600Hz, 1.2kHz, 2.5kHz, 5kHz, and 10kHz are selectable using the Left/Right buttons and each
can be adjusted to a setting between -6 to +6 using the Up/Down buttons.
(Make sure the Sound mode is set to "Standard".)
then set the audio delay between 0~300 milliseconds by using the Up/Down buttons.
Press the indicated areas to select Up/Down/Left/Right.
Press the Right button to select the next music file. Press the Left button to select the previous music file.
Use this option when the Subwoofer is not connected or need reconnection.
While powered off, press and hold the Up button for 5 seconds to perform ID SET. (See page 10.)
Press the VOL button to mute the sound. Press it again to unmute the sound.
the volume between -6~+6 by using the Up/Down buttons.
ENG - 6
Publicité
