Inventum HNK153 Mode D'emploi page 15

2
appliance description
HNK153
Electric heat pad
Dimensions: 50 x 30 cm
3 settings with an illuminated switch
Turbo heating
Automatic switch-off after 90 minutes
Detachable cord
100 Watt
Material: fleece
1. Mains plug
2. Mains cable
3. Control
4. Illuminated display for temperature settings
5. Sliding switch for ON/OFF and temperature settings
6. Plug-in coupling
3
intended use
CAUTION
This heat pad is only designed to warm up the human body.
4
operation
4.1 Safety
CAUTION
• The heat pad is fitted with a the INVENTUM SAFETY SYSTEM (ISS). This sensor technology provides protection against
overheating across the entire surface of the heat pad with an automatic switch off in the event of a fault. If the SAFETY
SYSTEM has switched off the heat pad, the temperature settings are no longer illuminated when switched on.
• Please note that for safety reasons, the heat pad can no longer be operated after a fault has occurred and must be sent to
the specified service address.
• Do not connect the defective heat pad with another control of the same type. This would trigger a permanent switch off via
the control's safety system.
4.2 Initial use
CAUTION
Ensure that the heat pad will not bunch up or become folded during use.
• First, connect the control to the heat pad by inserting the plug-in coupling.
• Then plug the mains plug into the socket.
4.3 Switching on
To switch the heat pad on, set the sliding switch for ON/OFF and temperature settings to setting 1, 2 or 3. The temperature setting is
illuminated when switched on.
5
2
3
1
6
4
English • 15