Publicité
Les langues disponibles
Les langues disponibles
TECHNICAL SPECIFICATIONS
Music Power Output:
150 W x 4 (110 W x 4*)
RMS Power Output:
76 W x 4 (56 W x 4*)
Frequency response:
20Hz ~ 20 kHz
Audio sampling frequency:
192 kHz
Distortion:
1 KHz <0.001%
Supply voltage range:
9V - 15V
Signal to noise ratio:
> 120 dB
Dynamic range:
> 100 dB
Standby current:
< 0.4 mA
Maximum operating current:
20 A
Dimensions (LxWxH):
185(206) x 114 x 40 mm
*without additional power supply
MAIN FEATURES
4-channel Smart Digital Amplifi er with iOS or Android App controlled audio DSP
n
functions
DSP-controlled 5-channel Preout (6 Volt) including REM-Out to control additional
n
amplifi ers
Plug'N'Play quick installation system via optional vehicle brand and model specifi c
n
ISO wire harness
Auto-Turn-On function
n
FUNCTIONALITY & ADJUSTABILITY
Bluetooth connection and control of DSP settings via iOS or Android Smartphone App
n
Freely confi gurable 3-way active crossover: High-/Low-/Band-/Bypass with
n
6/12/18/24dB/Oct. slope
Time Alignment in cm (0 – 230 cm) for front, rear and subwoofer channel
n
5 channel control: Gain, Phase switch and Mute function for each speaker
n
Freely confi gurable 7-band parametric Equalizer for front, rear and 4 speaker
n
Can save 5 memories in the amp and unlimited sound settings on the smartphone
n
Dynamic Bass setting for powerful performance without subwoofer
n
3D surround sound
n
– 4 –
INSTALLATION DIAGRAM
MOUNTING INSTRUCTIONS
1. Before you start with the installation, make sure you know the security code of your
headunit (if applicable).
2. Remove the headunit from the dashboard and disconnect the main wire.
3. Find a place for the A580DSP and connect the provided (or optionally available
car-specifi c) wire to the amp.
4. For more power output please follow these steps: Run a 10 mm
the (+) pole of the battery to the (BATT) terminal of the amplifi er. Use a fuse with the
related value of the cross section of the power wire. The distance between the B+
pole and the fuse holder must be 30 cm or less. Run the minus cable with the same
cross section from the (GND) terminal of the amp to the vehicle chassis ground.
Make sure that the contact surface is clean in order to get best conductance.
5. Make sure the switch "DSP" is set to "ON".
6. Connect the wire to the headunit.
7. Install the headunit back in the dashboard.
ORIGINAL CAR SOCKETS
HEAD UNIT
power wire from
2
– 5 –
Publicité
