InovTech G2000i Notice D'utilisation page 27

9. Transport / Storage
In order to avoid the generator leaking oil during transport or temporary storage,
make sure to switch off the generator, keeping it at a standing pose under
normal operations. After the engine is totally cooled, turn the ventilating pole of
the gasoline-filling lid to the "close" position thoroughly.
Warning
When transporting the generator:
Do not let the gasoline spill out of the gasoline tank. (The top of the
gasoline-filling tank should have no gasoline.)
When the generator is placed on vehicle, do not run the engine. You
should take the generator down from the car and operate it in the draught.
When you take the generator to the car, avoid exposing it to sunshine. If
it is put in sealed carriage for a long time, the high temperature of the carriage
may cause the gasoline to boiling away, thus leads to burn.
The cars loaded with generator should not bump on the uneven roads for
a long time. If it has to travel on such roads, the gasoline in the gasoline tank
should be discharged thoroughly in advance.
Before the generator is put into a long-time storage, you should:
1 Make sure the storage area is clean and dry.
2 Discharge the gasoline thoroughly.
Warning
Gasoline is very easy to burn or explode under specific conditions.
Smoke and flame are strictly forbidden near the gasoline.
A. Discharge the gasoline in the gasoline tank thoroughly into a proper
container
B. Turn the switch of the engine to the "CLOSE" position. Dismantle the
oil-discharging screw (Fig.1) on the carburetor and discharge the gasoline in
it into a proper container.
G2000i Inverter Generator
27