Publicité
Les langues disponibles
Les langues disponibles
SIDE SKIRT MAINTENANCE (DISC SYSTEM)
The side skirts function is to channel the waste water to the rear pick-up squeegee, helping contain the water with in the machines cleaning path. During normal
use the blades will wear in time. The operator will notice a small amount of water leaking out underneath the side skirts. A height adjustment can easily be made
to lower the blades so that all the water can be pick-up by the squeegee.
To reverse or replace the scrub system side skirt(s) ...
1
See Figure 4. Loosen the (2) side skirt Retainer Knobs (A) (2 per side) and pull the Skirt Assemblies (B) off from the scrub deck.
2
Remove all the hardware that holds both the (short and long) blades and retainers to the skirt housing.
3
Each blade has 4 working edges. Reinstall the blades to the skirt housing so a clean, undamaged edge points inside towards the scrub brushes. Replace
the blades as a set if they are nicked, torn or worn beyond their ability to be adjusted.
4
Reinstall the skirt housing assemblies onto the machine and adjust the blade for proper contact to the floor when the brush deck is placed in the scrub
position.
SIDE SKIRT HEIGHT ADJUSTMENT (DISC SYSTEM)
1
The side skirt housing knob retainer screw studs
have leveling Adjuster Collars (C), that are to be
raised or lowered to compensate for blade wear.
2
To adjust, remove the Skirt Assemblies (B) from
the Scrub Deck (D) to access the Adjuster Collars
(C). Adjustment Tip: The skirts Retainer Knobs
(A) can be loosened with skirts left on and the
Adjuster Collars (C) rotated by reaching under the
skirt housing.
3
Turn the Adjuster Collars (C) (Up or Down) to
where the blades just fold over enough when
scrubbing that all the waste water is contained
inside the skirting. Note: Make small adjustments
to obtain good blade wiping. Do not lower the
blades too much to where they fold over exces-
sively and cause unneeded blade wear.
SIDE SKIRT MAINTENANCE (CYLINDRICAL SYSTEM)
The side skirts function is to channel the waste water to the
rear pick-up squeegee, helping contain the water with in the
machines cleaning path. During normal use the blades will
wear in time. The operator will notice a small amount of
water leaking out underneath the side skirts. Skirt height
adjustment is automatic on this system. The skirt assem-
blies should move up and down freely for proper operation.
To replace the scrub system side skirt(s) ...
1
See Figure 5. Remove the (2) (A) Cotter Pins and
swing the Skirt Assemblies open. Remove the (B)
Screws and Nuts, remove the Skirts and replace.
50 - FORM NO. 56041408 - Hydro-Retriever
FRONT
D
B
A
C
B
™
3200 / BR 850
B
A
C
FRONT
A
FIGURE 4
A
C
A
C
FIGURE 5
Publicité
