Urmet 2Voice 1760/18 Mode D'emploi page 16

5. HOMEPAGE
The display of the video door phone is normally off and switches on automatically when a call is received.
The display can be switched on voluntarily by the user to access the video door phone homepage. Press
the key twice when the video door phone is in stand-by mode.
For video door phones in High rise block or Low rise block mode, access to the Homepage is
permitted to one device at a time, for a maximum of 5 minutes. If a user tries to access the Homepage
when it is already in use on another device, the video door phone will emit a dissuasion tone (4 beeps)
indicating that the page cannot be displayed at the moment.
The display shows the following screen:
On the Homepage, press
phone that you wish to set. When selection has been made press the
The configurations on the device are explained in detail below.
5.1 MUTE FUNCTION CONFIGURATION
The following parameter is used to configure the type of MUTE when the
(for further details see the chapter
On the homepage, select the
8H (default) to MUTE Timer.
The following
To configure the parameters of the MUTE Timer function, see the
chapter "Mute ring timing".
If you wish to reset the MUTE 8H function, simply repeat the procedure.
5.2 AUTOMATIC DOOR OPENER (MASTER VIDEO DOOR PHONE
ONLY)
The automatic door opener function allows the door to open automatically when a call is received, without
the need to answer.
On the Homepage, select the following
opener function.
16
, , and
function").
"Mute
icon and press the
icon is displayed to confirm that the parameter has been changed.
keys to select a function or parameter of the video door
key to change the configuration from MUTE
Parameter configuration booklet
icon and press the
key to confirm the selection.
key is pressed for a long time
key to enable the automatic door
in
DS1760-040A