Adler europe AD 2103 Mode D'emploi page 4

immediately remove the power plug or power adaptor from the socket. If the device is
powered, do not put hands in the water. Have the device checked by the qualified
electrician before using it again.
18. Do not touch the device or power adaptor with wet hands.
19. The device has to be turned off after every use.
20. Do not leave the unit on to the wall outlet or power supply unit unattended.
21. If the device utilises a power adaptor, do not cover it, because this can cause a
dangerous temperature rise and can damage the device. Always connect the power
adaptor cable to the device, and then connect the power adaptor to the power socket.
22. Keep the device out of the reach of children. Using the devices by children must be
supervised by adults.
23. The power cord should not touch hot parts of the device and should not be located near
other heat sources.
24. Do not wrap electric cable around the device.
25. Do not use a hair curling iron in the bath.
26. Do not remove dust or foreign bodies from the inside of the hair straightener using
sharp objects.
27. Do not use outdoors or where aerosols are being used or where oxygen is being
administered.
28. Do not cover the hair curling iron, it might cause the accumulation of heat in its interior
and it may cause damage or fire.
29. Hairsprays contain flammable materials. Do not apply them while using the device.
30. Do not use the device on people who are sleeping.
31. The device can be supplied only with the voltage specified on the housing.
32. During operation, do not place the device on wet surfaces or clothes.
33. After use, turn off and unplug the unit. Wait until the device cools down before storing.
34.During the operation ceramic plates heat up to high temperatures. Do not touch hot
parts of the hair curling iron and do not allow contact with the skin of the head, because it
may cause burns
35. The device is not designed to work with external schedulers or separate remote control
system.
DESCRIPTION OF THE DEVICE
1. Ceramic hair shaft
3. Clamp lever
5. On/Off indicator lamp
USING THE DEVICE
Use a device on washed, brushed and dry hair.
1. Before starting the device, the electrical wire should be fully unrolled.
2. Insert the plug into the socket.
3. Turn the switch of hair curling iron (6).
4. Indicator will light up, indicating the hair curling iron is working (5).
5. Start with separating a strand of hair.
6. Open the clamp (2) using the lever (3), place the strand so that the tips of hair protrude slightly from under the clamp. Close the clamp.
7. Wind the hair strand onto the iron, starting at the hair tips and coming closer to the head.
CAUTION: Avoid touching the head skin with the curling iron - this may cause burns.
8. In order to achieve strong effect keep the wound strand of hair on the curling iron for 20 seconds, or shorter for gentle curls or crimps.
9. After the use switch the curling iron off with the power switch (6), then remove the plug from the power socket.
CLEANING
1. Before cleaning, remove the plug from the socket and wait until appliance cool down.
2. The casing should be cleaned with a damp cloth. Do not submerge in water or other liquids.
3. Do not wind the power cable to the device.
TECHNICAL DATA
Voltage: 220-240 V ~ 50/60Hz
Power 25W, Max power 30W
2. Clamp
4. Handle
6. On/Off switch
4
7. Removable brush