Télécharger Imprimer la page

Kärcher WD 7.2 Serie Notice Originale page 17

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
Illustration
 Turn on the machine.
For appliances without built-in socket.
 Position I: Suction or blowing
 Position 0: Appliance is switched off
For appliances with built-in socket
 Position MAX: Suction or blowing.
 Position
connected electric tool
 Performance regulation: Reduce the
suction if necessary during vacuuming,
blowing or when working with an elec-
tric tool.
 Position 0: The appliance is switched
off. Electric tool is supplied with voltage.
Dry vacuum cleaning
Work only with a dry flat fold filter!
Illustration
Recommendation for appliances with-
out filter cleaning: To vacuum fine dust,
use the filter bag.
 The filling level of the filter bag depends
on the dirt that is sucked in.
Clogged filter bags can burst - therefore
make sure to replace the filter bag in a
timely manner!
The filter bag needs to be replaced
more frequently while sucking in fine
dust, sand, etc.
For appliances with ExPress filter clean-
ing: When vacuuming without a filter bag,
the filter cleaning indicator lights up red if
the flat fold filter needs to be cleaned.
 Use the filter cleaning.
ExPress filter cleaning
The ExPress filter cleaning is intended for
the vacuuming of large volumes of fine dust
without the filter bag inserted.
If the filter cleaning indicator is red, clean
the flat fold filter:
Illustration
 Press the filter cleaning key 3 x times
with the appliance switched on; wait
about 4 seconds between the individual
presses.
16
MAX: Vacuuming with
Note: After several filter cleaning proc-
esses or if the filter cleaning indicator is
red, check the container for its fill vol-
ume. Empty the container if needed.
Wet vacuum cleaning
 Attach the accessories to vacuum mois-
ture or wetness to the suction pipes or
directly to the handle.
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam
forms or liquids escape!
Note: If the container is full a float closes
the suction opening and the appliance
works at a higher speed. Switch off the ap-
pliance immediately and empty the contain-
er.
Working with electrical power tools
 Adapt the adapter to the connection di-
ameter of the electric tool using a knife
if necessary.
Illustration
 A) Plug the enclosed adapter onto the
handle of the suction hose and connect
the electric tool with the connection.
or
B) Use the flexible tool hose to gain
more flexibility in your work. Connect
this hose to the suction hose and to the
adapter and then to the connection of
the electric tool.
Illustration
 For appliances with built-in socket:
Connect the mains plug of the electric
power tool to the vacuum cleaner.
 Switch the appliance on (move the rota-
ry switch to the left to position
MAX) and start working.
Note: The suction turbine starts with a
delay of 0.5 seconds after the electric
tool has been switched on. After the
electric tool has been switched off, the
suction turbine will continue to run for
approx. 5 seconds to suck in the re-
maining dirt from the suction hose.
EN
– 4

Publicité

loading

Ce manuel est également adapté pour:

Wd 7.3 serieWd 7.5 serieWd 7.7 serieWd 7.700 p