Tyre Pressure; Seat Adjustment - GGP ITALY SPA SD98-108 Manuel D'utilisation

b) The engine stops when:
– the operator leaves his seat when the blades are engaged;
– the operator leaves his seat when the transmission is not in
"neutral";
– the operator leaves his seat with the transmission in "neu-
tral" but without applying the parking brake;
– the parking brake is engaged without disengaging the
blades.
– the speed change is activated (
( 4.32) with the parking brake on.
5.3 DIRECTIONS BEFORE STARTING WORK
Before starting to mow, it is necessary to carry out several
checks and operations to ensure you can work efficiently and
in maximum safety.

5.3.1 Seat adjustment

To change the seat posi-
tion, loosen the four fixing
bolts (1) and slide it along
the slots.
Once you have found the
right position, tighten the
four screws (1).
EN 16
4.22) or the drive pedal
1
1

5.3.2 Tyre pressure

Having the right tyre pressure is the main condition for ensur-
ing that the cutting deck is horizontal and mows evenly.
Unscrew the valve caps and connect a compressed air line
with a gauge to the valves and adjust the pressure to the indi-
cated values.
1,5 bar
(13 x 5,00-6)
1,0 bar
(15 x 5,00-6)
5.3.3 Filling with oil and fuel
NOTE
The engine manual indicates what type
of oil and fuel you can use.
With the engine off, check
the oil level. According to the
instructions in the engine
manual, this must be
between the MIN and MAX
marks on the dipstick.
1,2 bar
MAX
MIN