Carson Linde H40D Manuel D'instructions page 17

BINDING
Linking the transmitter identification code to
the receiver (binding)
START
1. First switch on the model.
To do this, push the main switch (power) on the underside of the
model to the "ON" position.
2. Now you're ready to activate the transmitter.
ON
OFF
1
STEERING TRIM
When the RC model does not run straight, adjust the steering trim.
Allow the model to move without adjusting the steering wheel so
that you can establish the direction of travel and correct it by pus-
hing the steering trim in the opposite direction from the direction
in which the RC fork lift is moving.
If the vehicle stops responding to the transmitter, switch the trans-
mitter and vehicle off and then back on again.
The transmitter and vehicle will link up with each other again.
The engine and warning sounds can also be switched on using a
separate switch.
To switch off after use, switch the model off, and then the
transmitter.
OFF
Engine
ON
sounds
OFF
Warning
ON
sounds
2
When model
OFF
Power
ON
When model
goes right goes left
17 // GB