Télécharger Imprimer la page

Krups KA990T41 Mode D'emploi page 25

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
n Take the body (e1) by the feed tube with the largest opening upwards.
n Insert the feed screw (e2) in the body (e1). (Fig. 3b)
n After soaking the skin overnight in lukewarm water, thread it onto the filler tube, leaving about 5 cm
hanging over the end.
n Fit the sausage filler tube (e9) onto the body (e1).
n Screw the cap nut (e6) fully home on the body (e1).
n Follow the same steps as for fitting the mincer attachment onto the appliance.
n Start the appliance by turning the speed control (a1) to speed 6.
n Insert the sausage meat into the feed tube.
n When the sausage meat shows at the end of the filler tube, stop the appliance. Tie a knot in the 5 cm of
overhanging sausage skin.
n Start the appliance again and hold the skin to obtain regular sausages; adjust the speed according to
the desired thickness.
n When all the sausage meat has been used up, turn the speed control (a1) to 0.
n Wait for the appliance to come to a standstill and remove the remaining sausage skin off the filler tube
and tie a knot.
n Release the accessory in the reverse order of the assembly.
- Mini-chopper (f) or grinder (g)
n Place your ingredients in the bowl (f2) or (g2), fit and lock the cover (f1) and (g1) on the bowl by turning
it clockwise. (Fig. 4a)
n Press the button (a3) on the right side of your appliance to release the multifunction head (a4) and raise
it to a
n Fit the bowl (b1) onto the appliance, the handle facing you, and turn it slightly to the left, until it locks in
place.
n Take the cover (b2) with your left hand, slide it into the rails on the front and the rear of the head (a4) until
it locks in place.
n Press the button (a3), located on the right of the appliance to release the multifunction head (a4), lower
it and press it
n Release and remove the cover (a6) from the outlet (a5) by turning it anti-clockwise. (Fig. 4b)
n Lock the mini-chopper (f) or grinder (g) on the outlet (a5) by turning it clockwise. (Fig. 4c)
n
n Turn the speed control knob (a1) to the desired setting depending on the ingredients and the desired
thinness.
n To stop, turn the speed control knob (a1) to 0.
With the mini-chopper (f), speed 4 to 10, you can:
- in a few seconds, chop: cloves of garlic, mixed herbs, parsley, bread, rusk for breadcrumbs, ham, etc.
- Prepare baby purées (150 g maximum)
- Maximum quantity of dried fruit (almonds, hazelnuts, etc., 100 g).
to lock it on the bowl (a click should be heard).

Publicité

loading

Ce manuel est également adapté pour:

Ka990S9900Ka990t42