Publicité
Les langues disponibles
Les langues disponibles
Installation
3.1. Before Installation
• Before installing, be sure the
opening measurements are
sufficient to receive the product
and that the appropriate electrical
and plumbing connections are
present.
• Refer to the nearest Authorized
Service Agent for installation
of the product. To make the
product ready for use, make sure
that the electricity installation
is appropriate before calling the
Authorized Service Agent. If not,
call a qualified electrician to have
any necessary arrangements
carried out.
• Place the product on an even floor
surface to prevent jolts.
• Install the product at least
12''(30cm) away from heat sources
such as hobs, heater cores and
stoves and at least 2''(5 cm)away
from electrical ovens.
• Product must not be subjected to
direct sun light and kept in humid
places.
• Appropriate air ventilation must
be provided around your product
in order to achieve an efficient
operation. If the product is to be
placed in a recess in the wall, pay
attention to leave at least 2''(5 cm)
distance with the ceiling and side
walls.
• Do not install the product in places
where the temperature falls below
23 °F (-5°C).
3.2.Installing the
plastic wedges
Plastic wedges supplied with the
product are used to create the
distance for the air circulation
between the product and the rear
wall.
1. To install the wedges, remove the
screws on the product and use the
screws supplied together with the
wedges.
2. Insert the 2 plastic wedges onto
the rear ventilation cover as
illustrated in the figure.
3.3.Adjusting the feet
After moving the freezer into place,
we recommend lowering the feet to
secure the product in place. You can
also adjust the feet if the product is
not balanced. Twist the feet in the
desired direction according to the
illustration below. Adjusting the feet
can also be used to align the doors.
10 / 20 EN
Freezer / User Manual
Publicité
