Publicité
Les langues disponibles
Les langues disponibles
Installation guide
Always use two people when setting up the base.
STEP 1
Place the bed base box in a desired location with the bottom of the box facing
up.
Remove the binding straps and packing materials, making sure not to puncture
the box with any sharp objects.
STEP 2
Remove the bed base from the box. Unfold the bed making sure to keep the
bottom of the bed facing upwards.
STEP 3
To install headboard brackets (sold separately),
see instructions on page 13.
Legs are shipped fully assembled. Alternative heights in 3" increments can be
achieved by removing leg segments.
To install the legs, thread the leg into frame, and tighten by hand. Do not over
tighten.
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
STEP 4
If installing a split unit, see pages 11-12.
Locate the battery backup strap and install (2) 9V
Alkaline batteries (not included). Store the strap
in a convenient location in case of an emergency
power outage.
(For operating instructions see page 14).
STEP 5
Uncoil input power cord (connected to control
box's power port) and plug into power supply.
STEP 6
Uncoil the power cord and connect to the power
supply. Place power supply on the ground and
extend from the base. Ensure that the power
supply and all attached cords are directed toward
the desired surge protector.
7
Publicité
