Duratech PLP-REM-300 Mode D'emploi page 13

LinkTouch ready transmitters: OLD & NEW mode
The "Old" mode is only used when your PLP-REM-300 is not "LinkTouch
ready"
The "New" mode is only used when your PLP-REM-300 is "LinkTouch
ready"
The mode can only be switched on transmitters which have a sticker
"LinkTouch ready" at the backside
Instructions to change the mode
1) Press and hold the "DIM" button
--->
2) Release the "DIM" button
3) Press "UP" to select the "New" mode or
4) Press "DOWN" to select the "Old" mode
The remote is now set to the selected mode and ready for use
the LED turns ON for about 2 seconds
turns OFF for about 4 seconds
starts to BLINK
LED
UP
DOWN
DIM
13