Duratech PLP-REM-300 Mode D'emploi page 12

Pairing the handheld transmitter to the PLP-REM-300
All handheld transmitters are already paired in the factory and ready to use.
In case a problem arises, the pairing process can be done as below:
1) Press the pairing button on the circuit board, inside the PLP-REM-300
---> The BLUE LED will start to blink
2) Within 25 seconds, push any button on the handheld transmitter.
---> If the remote is paired correctly, the BLUE LED will flash slowly for 5 times
---> UNPAIRING:
See RESET procedure: page 18
12
Pairing Indicator LED
(blue)
DuraLink
Pairing button