Duratech PLP-REM-300 Mode D'emploi page 10

Transmitter functions
OPERATION MODE:
OPERATION MODE:
(1) Lamp ON or OFF status is memorized after power down
(2) The green LED in the transmitter will light up as soon as you start pressing a button, and will stop
after 2 seconds, so you know exactly when to release the button.
(3) The lamps will be turned off for 30 seconds and then switched ON/OFF 3 times. This will set all
lamps to program 1: blue
10
PLC (default mode)
Short push (< 1 sec):
Toggle all lamps ON or OFF
Long push (> 2 sec
All lamps & "12VAC TO LAMPS" relay are turned OFF
Short push:
Go to next color program
Long push:
Toggle output A ON/OFF
Short push:
Go to the previous color program
Long push:
Toggle output B ON/OFF
Short push:
Select next dimming level:
100% -- 50% -- 25% ---> 100% -- ...
Long push:
Set lamps to Program 1 (blue) & full brightness
ON/OFF
Short push (< 1 sec):
Toggle all lamps ON or OFF
Short push:
Go to next color program
Long push:
Auto sync procedure
Short push:
Toggle output A ON/OFF
Long push:
/
Short push:
Toggle output B ON/OFF
Long push:
/
(1)
):
(2)
(3)
(1)