Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
2.2) Punching
Before punching:
• Check the correct match between die and punch.
• Keep hands away from the punching zone to avoid serious risk of injury!
– Position the tool on the trunking, at the desired hole centre (see Fig. 5).
NOTE: When punching holes in the base of trunking (see Fig. 6) with sides 50 mm (2")
high, it is necessary to fit the die after positioning the tool on the trunking.
44
Prior to removing the tool from the trunking, unscrew and remove the die.
43
– Push the button (10) pressed, the motor continues to operate: the ram will gradually
move forward until the hole is produced.
2.3) Punch release
35
– By pressing the pressure release button (201) placed on the body of the tool below
push-button (10), the ram will retract and the punch release; the extractors (49) will then
permit the tool to be disengaged from the trunking.
– Ensure that no punch slugs remain in the die. To remove a slug from the die, insert a
45
small drift through the locking screw (B or C), on to the slug and tap sharply.
2.4) Battery status
After releasing the operating button, the residual battery
capacity is automatically displayed for 5 seconds on the
indicator (15).
The number of LEDs illuminated indicates the residual
capacity:
201
10 LEDs illuminated: fully charged
08
5 LEDs illuminated: 50 % capacity
61
1 LED illuminated: minimum charge
3. WARNING
T
he Tool is unsuiTable for conTinuous use and should be allowed To
cool down following uninTerrupTed
,
insTance
having exhausTed a fully charged baTTery in one session
baTTery replacemenT for a few minuTes
o
bserve recommended resT periods also when using an exTernal power
.
supply
p
roTecT The Tool from rain and moisTure
. e
-
baTTery
lecTro
hydraulic Tools should noT be operaTed in pouring
.
rain or under waTer
04
30
52
03
34
02
33
74
75
13
205
56
55
15
57
45
54
58
59
12
60
78
,
;
successive punching operaTions
for
65
,
delay
.
79
77
. w
aTer will damage The Tool and
5
22
72
67
72
53
72
53
57
58
59
80
34
23
19
17
70
16
53
72
53
70
18
204
70
203
18
21
32
71
47
29
47
26
60
68
69
76
73
14
64
18
70
18
11
23
20
202
05
15
Publicité
Table des Matières
