GE GFD65 Manuel Du Propriétaire Et Instructions D'installation page 29

FINAL SETUP
LEVEL THE DRYER
1
Stand the dryer upright near the final location and
adjust the four leveling legs at the corners to ensure
that the dryer is level from side to side and front to
rear.
Lower Raise
PLUG DRYER IN
2
NOTE: Stacking installations may require a power
cord up to 6 feet in length.
49-3000206 Rev 1
Installation Instructions
Ensure proper
ground exists
before use.
DRYER START-UP
3
Press the Power pad.
NOTE: If the dryer has been exposed to temperatures
below freezing for an extended period of time, allow it to
warm up before pressing Power. Otherwise, the display
will not come on.
The dryer is now ready for use.
WARNING
- Electrical Shock Hazard
Disconnect power supply before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical
shock.
WARNING
- Shock Hazard
Certain internal parts are intentionally not grounded
and may present a risk of electric shock only during
servicing.
Service personnel – DO NOT contact the following
parts while the appliance is energized: water
valve, door switch, electronic board, igniter,
thermostats, flame detector.
29