Télécharger Imprimer la page

Toro SnowMaster e24 60V Mode D'emploi page 21

Publicité

Les langues disponibles

Les langues disponibles

After Operation
Shutting Off the Machine
1.
Release the auger lever and stop the machine.
2.
Turn the key to the O
from the machine
3.
Remove the battery pack(s); refer to
the Battery Pack from the Machine (page
Note:
Whenever you are not using the machine,
remove the battery pack(s) and the key from
the machine.
Note:
If the machine is turned on and left idling
or operating without the auger engaged for an
extended period, the motor shutoff timeout will
engage, shutting off the machine. When the
machine shuts off this way, it beeps to indicate
that the timeout was engaged.
To restart the machine refer to
Machine (page
15).
Removing the Battery Pack
from the Machine
1.
Lift up the battery-compartment lid.
2.
Press the battery pack-latch to release the
battery pack and remove the battery pack
(Figure
18).
Figure 18
1. Battery pack-latch
3.
Close the battery-compartment lid.
position and remove it
FF
(Figure
9).
Removing
Starting the
Preventing Freeze-up after
Use
In snowy and cold conditions, some controls and
moving parts may freeze. Do not use excessive
force when trying to operate frozen controls.
After using the machine, engage the auger to
clear any remaining snow from inside the housing.
Rotate the Quick Stick to prevent it from freezing.
19).
Shut off the machine, wait for all moving parts to
stop, remove the key and the battery, and remove
all ice and snow from the machine.
Clean off any snow and ice from the base of the
chute.
Rotate the discharge chute to the left and right to
free it from any ice buildup.
g431093
19

Publicité

loading

Ce manuel est également adapté pour:

3991439914t