Hansgrohe Vernis Blend Vario Wallbar Set 04969 0 Serie Instructions De Montage / Mode D'emploi / Garantie page 2

English
Technical Information
Flow rate
04969XX0
04970XX0
04971XX0
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• To prevent scald injury, the maximum output
temperature of the shower mixing valve (not
included) must be no higher than 120°F (49°C).
In Massachusetts, the maximum output temperature
can be no higher than 112°F (44°C).
• 04969XX0 only: This showerhead is for use with
automatic compensating valves rated at 1.9 GPM
(7.2 L/min) or less.
• 04970XX0 only: This showerhead is for use with
automatic compensating valves rated at 1.3 GPM
(4.9 L/min) or less.
• 04971XX0 only: This showerhead is for use with
automatic compensating valves rated at 1.1 GPM
(4.2 L/min) or less.
2
2.5 GPM (9.5 L/min)
1.75 GPM (6.6 L/min)
1.5 GPM (5.7 L/min)
• 04969XX0, 04970XX0, 04971XX0: The
screws and anchors included with this set are
suitable for use in a tile or other solid surface
wall. They are not suitable for use in an acrylic
or fiberglass shower enclosure. Please contact
the manufacturer of the enclosure regarding
recommended mounting locations, reinforcement
requirements, and mounting hardware.
The wallbar is not for use as a grab bar.
If a grab bar is required, install one
separately.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.