Publicité
Les langues disponibles
Les langues disponibles
KNOWING YOUr HAMMEr DrILL
1. Trigger Switch
2. Lock-ON Button
3. forward/Reverse Selector
4. Mode Selector
5. Chuck
6. Auxiliary Handle
7. Depth Gauge
8. Chuck Key
UNPACKING AND CONTENTS
IMPOrTANT:
Due to modern mass production techniques, it is unlikely the tool
is faulty or that a part is missing. If you find anything wrong, do not operate the tool
until the parts have been replaced or the fault has been rectified. Failure to do so could
result in serious personal injury.
CONTENTS IN PACKAGE
Description
Hammer Drill
Auxiliary Handle
Depth Gauge
OPErATION
WArNING:
on the rating name plate.
WArNING:
before adjusting, adding accessories, or checking a function on the tool.
SWITCH ACTION
Your tool is equipped with a variable speed trigger switch (1-fIG1). The tool speed is controlled by the amount of
pressure you apply to the trigger switch. By slowly increasing the pressure on the trigger switch, tool speed will
gradually increase until reaching maximum rated RPM.
To Start the Tool, simply depress the trigger switch. Increase tool speed by applying more pressure on the
trigger switch.
To Stop the Tool, release the trigger switch.
1/2" Hammer Drill
Operator's Manual
7
5
6
Q'ty
Description
1
Chuck Key
1
Operator's Manual
1
Always check that the power supply corresponds to the voltage
Always be sure that the tool is switched off and unplugged
4
1
8
Q'ty
1
1
GHD1250SE
3
2
FIG 1
Publicité
