EINHELL Bavaria BMP 440E Mode D'emploi page 8

Anleitung BMP 440 E SPK 1
GB
Operating Instructions for the
multi-saw
INTENDED USE
The multi-saw is designed for sawing wood, iron,
non-ferrous metals and plastic. It should only be
used with the appropriate saw blade.
Starting up (Fig. 1)
Switching on: Push down the safety lock-off (2)
and press the On/Off switch (1).
Switching off: Release the On/Off switch.
Electronic stroke rate control
The greater the pressure you exert on the On/Off
switch, the greater the stroke rate of the blade.
The general rules for cutting speeds for cutting work
apply.
Changing the saw blade (Fig. 2)
Always switch off and unplug the multi-saw before
working on the machine or changing the saw blade.
Unscrew the screw on the ram (4) using the Allen
key (8) included in delivery. Slide the blade between
the piston rod and the retention clip (9) in the ram
and make sure that the pin on the ram latches into
the hole in the blade. Re-tighten the screw using the
Allen key (8). The teeth of the blade must face the
direction of cutting.
Use as a jigsaw (Fig. 3)
Place the multi-saw on the material to be cut as
shown in Fig. 3. Switch on the multi-saw and push it
along against the material to be cut. Adapt your cut-
ting speed to the material.
8
13.02.2003 6:53 Uhr Seite 8
Technical data
Rated voltage:
Power:
Stroke rate:
Stroke height:
Cutting depth in wood:
Cutting depth in plastic:
Cutting depth in iron:
Sound pressure level LPA:
Sound power level LWA:
Vibration a w
Totally insulated
Weight
230 V ~ 50 Hz
440 W
0-4100 min. -1
10 mm
70 mm
125 mm
3 mm
86,2 dB (A)
99,2 dB (A)
6,7 m/s 2
II /
2.1 Kg