Publicité
Les langues disponibles
Les langues disponibles
OPERATION
WARNING!
Unplug the tool before changing
accessories
or
making
adjustments.
Never make adjustments while
the router is running.
Adjusting the Depth of Cut
The tool depth can be adjusted by using
the depth adjustment knob or a 3/8" socket
wrench.
When using the depth adjustment knob, fully
open the locking lever and rotate knob to
the desired depth of cut. One revolution of
the depth adjustment knob is equal to 0.2".
For fine adjustments less than 5/32", use
the independent scale on the depth adjust-
ment knob.
For deeper cuts:
1.
Align the "0" on the scale with the ar-
row on the tool.
2.
Rotate depth adjustment knob clock-
wise to desired depth measurement.
For shallower cuts:
1.
Align the desired depth measurement
with the arrow on the tool.
2.
Rotate depth adjustment knob coun-
terclockwise to "0."
Push in locking lever to fully closed
position when finished adjusting.
When using a socket wrench, place the router
upside down on a flat surface and fully open
the locking lever. Insert a 3/8" socket wrench
into the hole on the base and turn to desired
depth (Fig. 13). Push in locking lever to fully
closed position.
Fig. 13
Holding the Tool
These tools should be held using both
hands at all times for maximum control.
For Cat. Nos. 5615 & 5616 Series, see
Fig. 14:
Fig. 14
Alternate
strap positions
You can hold this tool using the body grip
and ball handle or both ball handles. The
body grip features an adjustable strap,
which can be attached in two different
positions for maximum control and
comfort.
For Cat. No. 5619 Series, see Fig. 15:
Fig. 15
Alternate handle positions
Grip the D-handle with one hand and place
the other on the ball handle.
For Cat. Nos. 5615, 5616 & 5619 Series:
One handle on these bases may be
adjusted to three different positions for
maximum control and comfort.
12
For Cat. No. 5625 Series only, see Fig.
16:
Fig. 16
The tool may also be held using
ball handles supplied separately with this
tool (Fig. 17).
Fig. 17
Ball
handles
WARNING!
To reduce the risk of injury, wear
safety goggles or glasses with
side shields.
To reduce the risk of injury, keep
hands, body and cord away from
the bit and all moving parts.
Before plugging the tool into a
power outlet, make sure the on/
off switch is in the "O" position.
Starting and Stopping Router Motor
For Cat. Nos. 5615, 5616 & 5625 Series:
1.
To start the motor, grasp the tool firmly
and push the On/Off switch to the "I"
position.
2.
To stop the motor, push the On/Off
switch to the "O" position and place
the router so the bit is away from you.
Hold the tool until the bit stops turning.
For Cat. No. 5619 Series:
1.
Push the On/Off switch to the "I" position.
2.
To start the motor, grasp the tool firmly
and pull the trigger.
3.
To stop the motor, release the trigger.
Locking the D-handle Base Trigger
(For Cat. No. 5619 Series only)
The lock button holds the trigger in the ON
position for continuous use (Fig. 18).
Lock button
Fig. 18
1.
To lock the trigger, hold in the lock
button while pulling the trigger. Release
the trigger.
2.
To unlock the trigger, pull the trigger
and release. The lock button will pop
out.
NOTE: D-handle base does not fit with Cat.
No. 5625 Series base.
13
Publicité
