Publicité
Les langues disponibles
Les langues disponibles
1.
Fit the extension pole between the polesaw
handle and the polesaw head to achieve the
maximum length.
2.
Slide the collars upwards.
3.
Turn the collars clockwise to tighten them.
Periodically check the tightness of the
connection of the collars.
7.6
USE THE SHOULDER STRAP
60°MAXIMUM
1.
Attach the carabiner to the carrying ring on the
pole.
2.
Put on the shoulder strap.
3.
Adjust the length of the strap so that the
carabiner is about the width of a hand below your
right hip.
7.7
CUTTING PREPARATION
Before you start to cut, make sure that
• Wear heavy gloves for maximum grip and
protection.
• Maintain a proper grip on the machine during
operation.
• Use your right-hand grip on the rear handle while
your left hand grip on the pole shaft.
• Keep your body to the left of the chain line.
• Never use a left-handed (cross-handed) grip, or
any stance that places your body or arm across
the chain line.
• Never stand directly under the limb you are cutting.
• Periodically examine the tightness of the collars
during operation.
7.8
INSTALL THE BATTERY PACK
English
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read and understand the instructions in the
battery and charger manual.
1.
Align the ribs on the battery pack with the
grooves in the battery compartment.
2.
Push the battery pack into the battery
compartment until the battery pack locks into
place.
3.
When you hear a click, the battery pack is
installed.
7.9
REMOVE THE BATTERY PACK
1.
Push and hold the battery release button.
2.
Remove the battery pack from the machine.
8
OPERATION
Remove the battery pack and keep hands clear of
the lock out button when you move the machine.
Examine the chain tension before each use.
8.1
EXAMINE THE CHAIN OIL
Do not use the machine without sufficient chain oil.
1.
Examine the oil level of the machine from the oil
indicator.
2.
Add oil if necessary.
8.2
START THE MACHINE
1.
Install the battery pack into the machine.
2.
Pull the lock-out button (1) upward.
9
WARNING
NOTE
IMPORTANT
NOTE
EN
Publicité
