Publicité
Les langues disponibles
Les langues disponibles
EN
3.
Press the trigger (2).
8.3
STOP THE MACHINE
1.
Release the trigger to stop the machine.
8.4
DELIMBING A TREE
Make sure that there is nothing or nobody in the area
where the branches fall.
• Stand opposite of the branch you will cut.
• Start to cut the higher branches.
• Then cut the lower branches.
• Cut downwards to prevent the bar from jamming.
8.5
LIMB TREE BRANCHES
Limbing is to remove the branches from a fallen tree.
1.
Keep the larger lower branches to hold the log off
the ground.
2.
Remove the small limbs in one cut.
3.
Limb the branches with tension from the bottom
to up.
4.
Keep the larger lower branches as a support until
the log is limbed.
B
A
WARNING
A
A
English
9
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the
plastic housing or components.
Remove the battery pack from the machine before
maintenance.
9.1
ADJUST THE CHAIN TENSION
Wear protective gloves if you touch the chain, bar or
areas around the chain.
1.
Loosen the chain cover (14) by turning the chain
cover knob (8) counterclockwise.
It is not necessary to remove the chain cover to
adjust the chain tension.
2.
Turn the chain tension screw behind the bar and
chain clockwise to increase the chain tension.
3.
Turn the chain tension screw counterclockwise to
decrease the chain tension.
4.
When the chain is at the wanted tension, tighten
the chain cover.
10
CAUTION
CAUTION
WARNING
CAUTION
NOTE
Publicité
