Publicité
Les langues disponibles
Les langues disponibles
Cleaning the Air Filter
If there is a noticeable loss of engine
power
4
Turn the choke knob to g
N
Take out the screw (1) and remove
N
the filter cover (2).
Clean away loose dirt from around
N
the filter.
Grip the filter element (3) at the
N
cutout (arrow) in the filter
housing (4) and remove it.
Fit a new filter element. As a
N
temporary measure you can knock it
out on the palm of your hand or blow
it out with compressed air. Do not
wash.
Replace damaged parts.
N
Installing the filter
Install the filter element in the filter
N
housing and fit the cover.
Insert the screw and tighten it down
N
firmly.
KM 110 R
Engine Management
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
1
2
Adjusting the Carburetor
The carburetor comes from the factory
with a standard setting.
On this machine it is no longer
necessary to adjust the carburetor.
It has been set at the factory to provide
an optimum fuel-air mixture in all
locations and operating conditions.
Adjusting Idle Speed
Engine stops while idling
H L
LA
Warm up the engine for about
N
3 minutes.
Turn the idle speed screw (LA)
N
slowly clockwise until the engine
runs smoothly – the cutting
attachment must not move.
Cutting attachment runs when engine is
idling
Turn the idle speed screw (LA)
N
counterclockwise until the cutting
attachment stops running and then
turn the screw about another 1/2 to
3/4 turn in the same direction.
English
15
Publicité
