Publicité
Les langues disponibles
Les langues disponibles
g If the engine is cold
e for warm start – also use this posi-
tion if the engine has been running
but is still cold.
Press the manual fuel pump
N
bulb (9) at least five times – even if
the bulb is filled with fuel.
Cranking
Place the power tool on the ground
N
so that it rests on the machine
support: Check that the working tool
is not touching the ground or any
KM 110 R
other obstacles – see also "Starting
/ Stopping the Engine" in the
KombiTool instruction manual.
Make sure you have a firm footing,
N
either standing, stooping or
kneeling.
Hold the unit firmly on the ground
N
with your left hand and press down
– thumb under the fan housing – do
not touch the throttle trigger or
trigger lockout.
NOTICE
Do not stand or kneel on the drive tube.
Hold the starter grip with your right
N
hand.
Pull the starter grip slowly until you
N
feel it engage and then give it a brisk
strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Continue cranking.
N
After no more than five pulls, move
N
the choke knob to e.
When engine begins to fire
Continue cranking.
N
As soon as the engine runs
Blip the throttle trigger immediately.
N
The slide control moves to the
normal run position F – and the
engine settles down to idle speed.
WARNING
Make sure the carburetor is correctly
adjusted. The working tool must not
move when the engine is idling.
Your machine is now ready for
operation.
Stopping the Engine
Push the slide control in the
N
direction of the arrow on the stop
symbol (h) to STOP-0.
At very low outside temperatures
As soon as the engine runs:
English
13
Publicité
