Personal Protective Equipment - RedMax CA-EX230 Manuel D'utilisation

Masquer les pouces

Table des Matières

Les langues disponibles

•

Only use the Product for the purpose it was intended

for.

•

Never use the Product if you are tired, if you have

drunk alcohol, or if you are taking medication that

could affect your vision, your judgement or your co-

ordination.

•

Never use the Product in extreme weather

conditions such as severe cold, very hot and/or

humid climates.

•

Never use a Product that is faulty. Carry out the

safety checks, maintenance and service instructions

described in this manual. Some maintenance and

service measures must be carried out by trained and

qualified specialists. See instructions under the

Maintenance heading.

•

Never allow children to use the Product.

•

Never allow anyone else to use the Product without

first ensuring that they have read and understood the

contents of the operator's manual.

•

Inspect the working area. Remove all loose objects,

such as stones, broken glass, nails, steel wire,

string, etc. that could be thrown out or become

wrapped around the cutter or cutter guard.

•

Keep unauthorised persons at a distance. Children,

animals, onlookers and helpers should be kept

outside the safety zone of 15 m while you work. Stop

the Product immediately if anyone approaches.

•

If you encounter a situation where you are uncertain

how to proceed you should ask an expert. Contact

your dealer or your service workshop.

•

Avoid all usage which you consider to be beyond

your capability.

•

Observe your surroundings and make sure that there

is no risk of people or animals coming in contact with

or affect your control of the product.

•

Do not use the Product in bad weather, such as

dense fog, heavy rain, strong wind, intense cold, etc.

Working in bad weather is tiring and can lead to

dangerous conditions, e.g. slippery surfaces.

•

Make sure you can move and stand safely. Check

the area around you for possible obstacles (roots,

rocks, branches, ditches, etc.) in case you have to

move suddenly. Take great care when working on

sloping ground.

•

Listen out for warning signals or shouts when you

are wearing hearing protection. Always remove your

hearing protection as soon as the engine stops.

•

The engine must be switched off before moving.

•

Never put the Product down with the engine running

unless you have it in clear sight.

•

The cutting tool must work away from the operator.

Never work with the tool towards the operator as this

may cause serious injury.

•

Always hold the Product with both hands. Hold the

Product on the right of your body.

•

Make sure your hands and feet do not come near

the cutter when the engine is running.

•

Always keep the tines close to the ground.

•

Always slow the engine to idle speed after each

working operation. Long periods at full throttle

without any load on the engine (i.e. without the

resistance that the cutting attachment exerts on the

engine when you are using the Product) can lead to

serious engine damage.

•

Pay extra attention when pulling the cultivator

towards you while working.

•

If heavy vibration occurs, stop the Product.

Disconnect the HT lead from the spark plug. Check

that the Product is not damaged. Repair any

damage.