Craftsman CMXEVBCV945L Guide D'utilisation page 5

Assemble as follows:
1. With cord disconnected from the receptacle and tank
cover removed, turn tank upside-down so bottom is facing
up.
2. Take caster feet 4 and place into slots on tank. Fig. 1.
Fig.1
3. Secure caster feet 4 to tank with screws provided 9 .
Fig. 2.
Fig. 2
4. Insert casters 5 into caster feet 4 by placing the caster
stems into the holes provided. Apply pressure and twisting
motion until casters snap into place. Fig. 3.
Fig. 3
5. Return tank to upright position.
GENERAL SET UP
6. Before replacing tank cover, refer to Dry Pick Up or Wet
Pick Up Operation in user manual to ensure you have the
proper filters installed for this cleaning operation.
7. Replace tank cover, and apply pressure with thumb to
each latch until it snaps tightly into place. Make certain all
lid latches are clamped securely.
8. Insert hose 12 into inlet of tank 2 . Do not over-tighten.
9. Attach the extension wands 11 to the accessory end of
the hose 12 . Twist slightly to tighten the connection.
Fig. 4.
Fig. 4
10. Attach one of the cleaning accessories (depending on
your cleaning requirements) on the extension wands 11 .
Twist slightly to tighten the connection. Fig. 4.
11. Plug the cord 7 into the wall outlet. Your cleaner is
ready for use. I = ON, O = OFF
FILTER INSTALLATION AND CLEAN UP
Dry Pick Up Operation
NOTE: Never use the vacuum for dry pick up without a dry
use filter installed on the lid cage. Using the vacuum without a
filter will cause dust to discharge from blower port and cause
damage to motor.
INSTALLING AND CLEANING THE CARTRIDGE
FILTER 14 , 15 :

WARNING:
THE PLUG FROM THE WALL OUTLET BEFORE
REMOVING THE TANK COVER.
NOTE: If foam sleeve 16 is installed on lid cage, remove before
installing the cartridge filter 14 .
12. The cartridge filter 14 can be used for dry pick up and
small quantities of wet pick up. Installation is the same
for both. When picking up large quantities of water
we recommend using a foam sleeve 16 instead of the
cartridge filter 14 . When picking up fine dust or powders
a high efficiency filter bag (not standard with all models)
must be used with the cartridge filter.
NOTE: If cartridge filter 14 has been used for wet pick up, it
must be cleaned and dried before using it for dry pick up.
ENGLISH
ALWAYS DISCONNECT
4