S&P TLS-503T Mode D'emploi page 10

ENGLISH
1. INSTRUCTIONS FOR USE
Please read these instructions carefully before starting the convector heater as they provide
important information for your safety and for the correct use of the convector heater.
The TLS-501 and TLS-503 Turbo convector heaters meet the European electrical safety re-
gulations. The accessories required for assembly, mobile device are indicated in Figure 3.
Please check that the convector heater is in perfect condition when you unpack it as any fac-
tory defects are covered by the S&P guarantee.
2. SAFETY WARNINGS
• Do not use this convector close to a bath, shower or swimming pool.
• Whilst the convector is in operation, the cable must not be in
contact with the hot area of the device.
• Do not use the convector to dry clothes.
• Do not handle the convector with wet hands.
This symbol means "Do not cover" this appliance with ob-
•
jects that prevent the air circulating freely. Obstructing the air-
fl ow increases the risk of overheating.
• If the fl exible power cable is damaged, it should only be replaced
in one of our Repair Workshops or by qualifi ed staff in order to
avoid a dangerous situation.
• Double insulated appliance
ding.
• Do not place the convector next to a wall made of combustible
materials (wood, plastic, etc).
• Infl ammable objects must not be left within 50 cm of the hot air
circuit (curtains, etc).
• Do not use the appliance in rooms whose area is less than 4m2.
• Do not place the device where are air drafts, because can disrupt
its proper functioning.
10 10
, therefore does not require groun-