Adapters For Danfoss - eQ-3 K Mode D'emploi

One of the enclosed adapters is required for installation
on Danfoss valves. The arrangement of the suitable ad-
apter ring for the appropriate valve can be found in the
following figures:
Take care during installation that you do not trap your
fingers between the two halves of the adapter!
The Danfoss valve bodies have elongated indentations (E)
running all around (see arrow), which also ensure better
seating of the adapter after it has been latched into place.
When installing, please ensure that the spigots inside
the adapter (D) are in the same position as the inden-
tations (E) on the valve.Latch the adapter, which cor-
responds to the valve, completely onto the valve body.
The RA and RAV adapters have been produced with pre-
tension to aid better seating. Use a screw driver during in-
stallation if necessary and bend these gently upwards in
the area of the screw. After they have been latched onto
the valve body, fasten the adapters with the enclosed
screw and nut

6.1. Adapters for Danfoss

35