Black & Decker BDH2000PLA Mode D'emploi page 5

• Lower the appliance onto the charging base. The blue
LED (3) in the base of the appliance will illuminate to
indicate that it is charging.
• When charging is complete, the LED will turn off.
• The charger may become warm during charging.
This is normal and does not indicate a problem.
While it is safe to leave the appliance connected to the
charger indefinitely, to reduce power consumption, we
recommend unplugging the charger after 4 hours.
SWITCHING ON AND OFF (FIG. E)
• To switch the appliance on, slide the on/off switch
(1) forward to position I.
• To switch the appliance off, slide the on/off switch
(1) back to position 0.
OPTIMIZING THE SUCTION FORCE
Rotating the bowl agitates the filter to remove dirt;
however, in order to keep the suction force optimized,
the dust container and filters must be cleaned regularly
during use.
CLEANING THE FILTERS
(FIG. F - I)
WARNING:
Hazard: Never use the appliance without the filters.
Optimum dust collection will only be achieved with clean
filters.
CAUTION:
when dust container is removed.
Both the plastic pre-filter (12) and the pleated filter
(13) are re-usable and should be cleaned regularly.
• Pull the door latch (9), open the transparent door
(8) as shown in figure F and empty contents into a
waste basket.
• Push and hold the release bowl button (5) on the
nozzle.
• Rotate the nozzle toward the bottom of the
appliance as shown in figure G.
• Pull the dust container to the side, and away from
the base of the appliance.
• Remove the pleated filter from the pre-filter by
pulling firmly as shown in figure H.
• Tap the filters vigorously to remove loose dust.
Projectile/Respiratory
Do not turn appliance on
D
E
F
G
H
5
12