Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
Insert visor rear flange first. Rear flange inserts between the trim and the exterior surface. NOTE: REAR FLANGE
DOES NOT GO INTO THE WINDOW CHANNEL. The front & top flange slides into the window channel.
3
Cross section of Rear Flange Installation Area.
Trim
4
NOTE: It is necessary to both hold the visor up into the
window channel AND pull the bottom of the visor slightly
outward while raising the glass to seat visor properly.
6
4 Piece Set
Install the rear visor using the same preparation and installation methods as front visor. Note
that the top & rear flanges slide into the window channel, and the front flange fits between the
8
NOTE: Actual application may vary slightly from illustrations.
Insert rear flange between
trim and exterior surface.
REAR FLANGE DOES NOT
GO INTO THE WINDOW
CHANNEL
Exterior Surface
Repeat steps 1 thru 8 for remaining visors
Trim
Apply pressure to all flange edges to ensure proper
adhesion. Remove tape liner by pulling on free ends.
5
Continue to apply pressure to ensure that the visor
remains properly seated inside the window channel
as window is slowly closed. Leave window up for 72
hours to secure visor to window channel.
72
50°F / 10°C Min.
7
If the visor does not seat correctly, roll down
rubber & window frame.
Page 2 of 3
Exterior Surface
window and repeat Step 6.
Publicité
