Publicité
Les langues disponibles
Les langues disponibles
5
make sure you are using a main fuse protection
for the +12V-power input of the amplifier within
max. 20–30 cm of the car battery and power cables with
an amperage adequate cross-section and main fuse
(for details see section E: „Connecting").
6
The grOUnD/gnD cable (0 V) should have the same cross-
section as the +12V power cable. Make sure to get a good
chassis ground contact, because poor ground contacts are the
cause for most power problems with car audio installations.
7
Make sure no power, signal or speaker lines are shorting
to chassis ground by using rubber grommets wherever a
cable has to pass through any metal part of the vehicle.
important: Before any wiring, always remove the battery ´s
negative terminal to prevent short-circuiting. The last lead to be
connected in every installation is always the negative terminal.
Connect this lead only after having completed and checked all
other connections.
All manuals and user guides at all-guides.com
31
31
Publicité
