Publicité
Les langues disponibles
Les langues disponibles
Whirlpool
10. Complete the Finished Wall
NOTE: The center apron panel is removable do not restrict access with the finished wall construction.
- If you have not already done so, carefully remove the protective tape from the whirlpool rim.
- Cover the framing with water resistant wall material. Seal the joints between the whirlpool rim edge and the
water resistant wall material with silicone sealant.
- Tape and mud the water resistant wall material. Install the finished wall to the water resistant wall material. Seal
the joints between the whirlpool rim and the finished wall material with silicone sealant.
- Install the faucet trim according to the instructions packed with the trim.
11. Removing the Apron
- Press the suction cup (provided) firmly onto the flat apron surface near either bottom corner of the apron.
- Steadily pull the suction cup outward to free the apron from the fasteners.
- Reinstall the apron by first pressing the top into the apron pocket to compress the seal located along the top of the
apron pocket. Then swing the apron bottom into the apron pocket, making sure all four apron corners engage the
fasteners. The apron should be flush with the surrounding surface.
12. Clean-Up After Installation
- When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the whirlpool
surface. Use warm water and a liquid detergent to clean the surface.
- Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners containing
petroleum distillates to remain in contact with any whirlpool surfaces for long periods of time. Remove plaster
by carefully scraping with a wood edge. Do not use metal scrapers, wire brushes, or other metal tools. Use a
powder type detergent on a damp cloth to provide mild abrasive action to any residual plaster.
A
1011609-2-
Framing
Water-Resistant
Wall Material
Finished Wall
Apply silicone
sealant to the joint
between the
whirlpool and the
finished wall
8
Whirlpool
Fastener
Press the
suction
cup onto
the bottom
corner of
the apron,
Apron
then pull
steadily
outward
Reinstall the apron
by pressing the
apron against the
seal, then swing in
the apron bottom
Apron
Kohler Co.
Publicité
