HomeMatic IP HmIP-P-DRG-DALI Notice D'installation Et D'emploi page 41

E35
E36
E37
E38
E39
8 Restoring factory settings
The device's factory settings can be restored. If you do this, you will
lose all your settings.
To restore the factory settings of the device, please proceed as follows:
• Press and hold down the system button (A) for 4 seconds until
the LED (A) quickly starts flashing orange (see figure 12).
• Release the system button.
• Press and hold down the system button again for 4 seconds, until
the LED lights up green (see figure 13).
• Release the system button again to complete restoration of the
factory settings. The device will perform a restart.
DALI exchange
failed
(no device present
so far)
DALI exchange
failed
(no missing device)
DALI exchange
failed
(more than one
missing device)
DALI exchange
failed
(no new device
found)
DALI reset failed
Restoring factory settings
No device added so far. An ex-
change is therefore not possible.
Make sure that a device is no
longer connected and try again.
Make sure that only one device
is no longer connected and try
again.
Make sure that a new device is
connected and try again.
Check the DALI bus and try
again.
41