Tv/Vcr Hookups - Sony STR-GA8ES Mode D'emploi

Getting Started
4
Connect the second amplifier to SURROUND
OUT CENTER, and connect the center speaker to
this amplifier.
The center signal is output from the SURROUND
OUT CENTER terminal.
Receiver
SURROUND OUT
REAR
5
Remove the cover on the POWER SWAP selector
and set the selector to the SWAP position.
After you have completed the setting, reattach the
cover to the selector and plug in the power cord.
To adjust the volume
Set the volume control of the separate amplifiers to the
maximum position and adjust the volume level with the
volume control of the receiver.
Notes
• For best results, we recommend using a pair of equivalent
amplifiers to boost front and center speaker output. You
can, however, connect the center speakers to the CENTER
SPEAKER terminals if you only have one additional
amplifier.
• Do not use the terminals labeled CENTER SPEAKER or
REAR SPEAKERS if you connect two additional
amplifiers. Make connections as shown above.
• If you want to turn off the power swap function, set the
POWER SWAP selector to the NORMAL position.
Where do I go next?
To complete your system, go to "AC Hookups" on page 9. If
you want to connect video components to enjoy surround
sound when watching TV programs or video tapes, go on to
the next section.
8 EN
Amplifier 2
(for center speaker)
INPUT
CENTER
WOOFER
POWER SWAP
SWAP NORMAL

TV/VCR Hookups

Overview
This section describes how to connect video
components to the receiver. For specific locations of the
jacks, see the illustration below.
TV/DBS LD VIDEO 2 VIDEO 1
5.1 INPUT
What cables will I need?
• Audio/video cable (not supplied) (1 for each TV or LD
player; 2 for each VCR)
Yellow
White (L)
Red (R)
• Video cable (not supplied) (1 for a TV monitor)
Yellow
Hookups
The arrow ç indicates signal flow.
TV tuner or DBS (Digital Broadcasting Satellites) receiver
Receiver
TV/DBS
VIDEO
IN
AUDIO
IN
L
R
Monitor
If you are using your TV as a monitor, do not connect
anything to the TV IN jacks.
Receiver
MONITOR
OUT
OUT 2 OUT 1
MONITOR
Yellow
White (L)
Red (R)
Yellow
TV/DBS
OUTPUT
VIDEO
AUDIO
L
R
Monitor
INPUT
VIDEO