Publicité
Les langues disponibles
Les langues disponibles
■ Using the Rubber Cushion (Optional)
(If there is an existing Rear Support Bracket on the Fire Wall of Car.)
Cover Mounting Bolt
(D
on the rear of the unit with Rubber Cushion (Optional), and mount it into existing
Rear Support Bracket.
Rear Support Bracket
(existing on the car)
\ Rubber Cushion (Optional)
-\
© Mounting Bolt
N © Mounting Collar
15
3.
Plug the Power Connector (§).
4. After installation reconnect the negative (-) battery terminal.
To Remove the Unit
a) Remove the removable face plate as shown in next page. (To Remove the Removable Face Plate)
b) Remove the trim plate with a screwdriver as shown in the figure.
c) Pull out the unit while pushing the lock lever using screwdriver.
d) Remove the unit pulling with both hands.
CQ-DPG550/DPG500EUC
21
Publicité
