Kohler K-1110 Guide D'installation page 28

Operating Sequence (cont.)
Select and activate the air flow mode icon.
Press the up or down button to verify the air flow increases or decreases.
Confirm Individual Zone Control
Select and deactivate Zone 1.
Verify that air stops flowing in the corresponding zone.
Activate Zone 1.
Repeat for Zones 2 and 3.
Confirm Surge Mode Operation
NOTE: The surge mode cycles the speed of the blower motor between maximum and minimum settings
over an adjustable period of time. Six cycle times are available ranging from about 10 seconds to about
one minute. The up and down buttons control the cycle time when in the surge mode. The surge mode
will operate with any zone or all zones selected. The indicator bar shows the speed of the surge mode.
Select and activate the surge mode.
Verify that the air flow cycles between minimum and maximum.
Increase or decrease the speed of the surge cycle by pressing the up or down button.
Turn the unit off.
Automatic Purge Cycle Operations
NOTE: The automatic purge cycle occurs after the bath is drained. It operates at low speed for about two
minutes to remove any residual water from the air channels.
If required, fill the bath to a level at least 2" (5 cm) above the top of the highest airjet.
Drain the bath.
When the water level drops below the level sensor probes, verify that the blower motor starts at low
speed.
After about two minutes, verify that the blower motor stops.
Manual Purge Cycle Operation
With the bath drained, rotate the ring on the user keypad to the purge cycle icon.
Press the "OK" button.
Observe that the blower motor starts in purge cycle to blow any residual water from the air
channels.
After the blower motor has operated for about two minutes, observe that the blower motor stops.
NOTE: If the bath is provided with chromatherapy, go to "Chromatherapy Operation (If Equipped)" to test
the lights. If not, the installation is complete.
21. Chromatherapy Operation (if Equipped)
For Bath with Airjets with Chromatherapy Only
NOTE: Chromatherapy may be used with all modes of operation. Chromatherapy may also be used when
the blower motor is not operating.
1035472-2-G
All manuals and user guides at all-guides.com
28 Kohler Co.