Kohler K-1110 Guide D'installation page 24

16. Complete the Finished Deck
For Drop–In Installations
If you have not already done so, carefully remove the protective tape from the bath rim.
Cover the framing with water-resistant deck material. Seal the joints between the bath rim edge and
the water-resistant deck material with silicone sealant.
Install the faucet trim according to the instructions packed with the trim.
17. Complete the Concrete Installation
For Island Installations
If you have not already done so, carefully remove the protective tape from the bath rim.
Apply mortar and tile to any wall, deck, and surround material as needed.
Apply a bead of sealant where the tile meets the bath surface.
Install the faucet trim according to the instructions packed with the trim.
18. Clean-Up After Installation
For All Installations
Clean the area around the blower motor of all dust and debris.
Use warm water and a liquid detergent to clean the surface of the bath. Do not use abrasive
cleansers, as they may scratch and dull the bath surface. Do not use powdered cleaners unless the
cleaner is fully dissolved in water. Solid substances could block the airjets. Do not use bleach or
ammonia cleaning solutions. Chemically active cleaning solutions can damage the bath surface.
Refer to the homeowners guide for normal cleaning recommendations.
1035472-2-G
All manuals and user guides at all-guides.com
Finished Deck
Apply silicone sealant to the edges
Material
of the water-resistant deck
material and the finished deck.
Framing
Bath
Water-Resistant
Deck Material
24 Kohler Co.